Walk to the edge of any roof you are about to replace and look down. That strip of metal along the eave is drip edge. It is also one of the first lines to go missing from an estimate.
- On one sample roof, drip edge was worth $615.
- Two photos and one measurement support it.
- You document the scope. You do not argue coverage.
Why it is owed
Drip edge comes off with the shingles. It gets bent and nailed through, so it does not go back on. Many local codes also call for it at the eaves and the rakes.
The photo to take
One close shot of the eave edge and one of the rake, with a tape measure in the frame. After tear-off, photograph the old metal too.
What you will hear
"We reuse the drip edge."
What to send back is a photo of the bent, nailed-through metal after tear-off, the length from your measurement report, and the local code section if one applies. A document answers the question. An opinion does not.
It rarely travels alone
On that same sample roof, starter course ($323) and ridge cap ($482) were missing too. Three small lines, $1,420 together.
- You upload the estimate. Every missing line comes back coded and priced.
- Each line carries a short lesson like this one: the reason, the photo, what to send.
- Written in Xactimate, checked by a human, backed by the latest technology.
- We never contact your carrier. You send it.
About a minute. No account to set up.
Keep reading
Dollar figures are from a sample roof priced for illustration, not a customer result. Prices vary by area and month.
